Printing paste has the property of

Printing of Polyester (PET) with disperse dye

Which of the following one is considered as the main disadvantage of the lea-strength tester ?

Which of the following fabric will break first during hydraulic bursting strength tester ?

The FAST system is used to measure the properties of fabric which affects..............of the fabric.

The property that Kawabata Evaluation System (KES) does not measure is

The mean range of the count test results on a 50s cotton yarn is 3.4. Four bobbins are tested in each sample. Calculate the percentage mean deviation.

Find out the equivalent worsted count of yarn, if the yarn is having 20 tex.

40 S yarn cone package fixed in the warpe's creel has a yarn mass of 1.5 kg. If the  warper's beam are produced for a warp length of 7800 m, calculate number of doffs for which the cone will supply the yarn.

Tip bunch in the pirn is given for

In case of multi phase, weaving, the maximum weft insertion rate is around

Dobby shedding mechanism control upto..........heald frames than tappet shedding mechanism.

If a ring yarn produced from a roving with a CV value of 4% has an uneveness of CV = 13.6%, then the CV added by the ring spinning process is

The approximate number of fibres in a card silver in between ..........and ............

The fibres in card silver are relatively

For fines silvers, what is the relation between the diameter of trumpet bore (d) and linear density in tex ?  

The yarn relationship between yarn diameter and twist is 

The blending technique that gives homogeneous mixing of fibre is

Front top roller of a drafting system would normally arranged (when looked from the front side as the drafting system) on the front bottom roller with

The combing force increases with

In cotton combing, oil extraction increases

Match the following :

The glass transition temperature of nylon 6 is

In the context of viscose fibre production, choose the correct statement

A filament yarn of 300 denies is being spun at a take up speed of 1200 m/min. Assuming the density of the melt as 1.2 g/cm3, the throughput speed of 1200 m/min. Assuming the density of the melt as 1.2 g/cm³, the throughput speed (cm³/min) at the spinneret would be

Crimp cutting of synthetic filaments are done for

Drawing of synthetic filament does not lead to an increase in

Surging defect in yarns occurs in false twist texturising due to variation in

......................fibre is more susceptible to oxidative and radiation induced degradation even at room temperature

......................method can be used to measure degree of set