The Sardar Sarovar project is located in
Which ministry conducts the decennial census in India?
Who was the President of Indian National Congress when 'Poorna Swaraj' resolution was passed?
Kolar mines in Karnataka is famous for :
Name the river that flows through silent valley :
Gandhiji broke the salt law on :
Who was the founder of 'Samathwa Samaj'?
Which is the longest river in South India?
Telangana State was formed on:
SAARC summit of 2014 was held at:
Anamudi peak is located in which district of Kerala:
Bachpan Bachao Andolan was started by:
”No Caste,No Religion,No God for man” Who said these words?
Who among the following was known as ‘Shanmughadasan’?
’Operation Lehar’was associated with
Who wrote the book’Mokshapradipam’?
What is the position of India in Human Development Index 2014?
Gandhiji met Sree Narayana Guru in:
Quit India movement was started after the failure of:
What is the Motto of National Games?
Specific heat is the amount of heat required to rise the temperature:
Pulverized coal is:
The I.P (indicated power) of an engine is always ------------- the brake power.
Volumetric efficiency is the ratio of:
Water hammer is developed in a :
The time for half amount of radio active isotope to decay is known as:
Acme thread has .......... degree angle.
As steam expands in turbine:
pvn=constant,It is the relation for polytrophic process,if n=0 then the process become:
Which of the following enters to the super heater of a boiler?
............ is reduced in turning operation.
A hydro electric power station is commonly constructed at:
Morse test is conducted to find out the indicated power of:
”Intensity of pressure at a point in a fluid at rest is same in all directions”,this law is:
One litre of water occupies a volume of:
The ratio of strength of solid to hollow shaft, both having outside diameter D and hollow having inside diameter D/2 in torsion is:
The bending moment is maximum on a section where the shearing force:
A structure used to dam up a stream or a river,over which the water flows is called:
The most efficient air standard cycle is:
The function of an inter cooler in multi stage compressor is:
The brake power of an internal combustion engine can be found out with the help of:
The property of the fluid by which molecules of different kinds of fluids are attracted to each other is called
In water tube boilers:
The object of producing the draught in boiler:
The efficiency of a boiler plant ............ with mechanical draught:
Venturimeter is used to:
The property of a material which allows it to be drawn into smaller section is called:
Kinematic viscosity is the:
Which thermodynamic law provide the basis of temperature measurement?
In one dimensional flow,the flow:
A cylindrical section having no joint is called:
Cavitation in hydraulic machinery:
The resilience of a material is considered when it is subjected to:
According to Darcy’s formula loss of head due to friction in a pipe is:
Which of the following has no unit?
Materials having same elastic properties in all directions is called:
The ratio of work done per cycle to the stroke volume of the compressor is known as:
The maximum bending moment due to moving load on a simply supported beam,occurs:
The characteristic equation of gas is
The mechanical efficiency of an impulse turbine is:
C.R.D.I. is related to:
E.G.R. is employed to reduce:
VVT- i is employed to operate:
Forward efficiency is related to
HUD is a term linked with ............... of the modern vehicle.
Anti dazzle devices are used in ............... system
FFV stands for:
Schrader valve appears on:
EBD is a ............ device in modern vehicle.
Viscous coupling is employed instead of ------------ in modern vehicles
Soot is a type of:
Cowl is a part of:
Blow by gases can be relieved by
Expansion tank is employed in ……………… system.
A.C.Mechanical pump is employed in:
Pulsation of clutch pedal is due to:
Car can stop in gear by using
Torque transfer at an angle is provided on propeller shaft by using:
Scrub radius is:
The ratio of side force to the slip angle is called:
Torsion bar is used for:
The unbalanced wheel gives rise the problem of:
Skidding of wheels avoided by:
Brake caliper is:
The distance between the centre lines of the front and the rear axles is called:
Ackermann steering mechanism,is used for:
Top of the wheel slants vertically outward is called:
Over drive is used to:
Volumetric efficiency of an engine is increased by:
Cold rating is associated with:
Spark developed in spark plug when:
Turn ratio is associated with:
R.P.M of an engine can be measured with:
Folo ............ Thru drive employed in:
Sealed beam unit is a part of:
M.A.C.T is related to:
Speed limit is included in:
Super elevation is ----------------- of a horizontal curved portion of a road.
A fare that is proportionate to the distance travelled is known as:
The Motor vehicle to which semitrailer is attached is called: