Screen Printing Inks usually dry by a combination of ----- and ------- process.
The packaging board that has middle layer of mechanical pulp sandwiched by bleached chemical pulp
The size of A3 paper
Binding printed matter by piercing the pages and securing them together with wire or thread
Two or more folds parallel to each other with adjacent folds in opposite directions
In saddle stitching, the thickness of the bound should not exceed
The operation of putting lines on blank or preprinted sheets
'Squareness' of trimmed paper is obtained by utilizing the ------------- component of the cutting machine.
Breaking of the fibers in paper or board to facilitate folding or bending
In binding, the stitch at the top and bottom of the spine which connects each signature to the following one.
------------- involve the selective charging of a dielectric surface by exposure to an electron beam or discharging of a photo conductive surface by exposure to light
--------------------- is the ink metering roll in flexographic process and is made of either steel or ceramic materials.
A cylinder base design in which the supporting shaft is permanently attached to the printing cylinder
The exposure done to harden or cure the base of the flexographic plates
Match List I with List II and select the correct answer using the codes given in below list :
List I
(Printing processes)
List II
(Image carriers)
Intaglio printing process refers to
Specks of dust on the clear areas of the positive as on the contact frame glass causes
The coating plated over the surface of a gravure cylinder to have easy engravability
Whenever the web stops, the gravure cylinder must continue to rotate slowly in the ink pen and called as
The angular measurement where the surface of the gravure cylinder is free of ink prior to printing
The impression roller that automatically change its shape to conform to the amount of impression roller deflection
In -------------- printing problem, it appears as blotches and streaks in the solids and tones of an overprinted ink film on a press sheet.
The plate height above bearer is 0.007", the blanket height above bearer is 0.003" and the distance between bearer is 0.008" for the non-bearer contact press. The squeeze obtained from this setting is
-------------- roller is used to evenly distribute the dampening film
The press which can print atleast one color on both sides of a sheet in a single pass through the press
In ----------- direction, the blanket is to be mounted around the circumference of the blanket cylinder.
-------------type of blanket resists smash in a better manner.
The roller substituted for form roller to reduce ghosting
The formula to calculate the print contrast
A revolving, motorized cone-shaped device that runs on a track from one end of the ink fountain to the other, keeping the ink soft and flowing